Vibro-Meter 200-566-000-114 VM600 IOC4T I/O Interface Card

Product Brief Description

Vibro-Meter 200-566-000-114 is the IOC4T I/O card for Meggitt VM600 machinery protection system. It is a 4-channel input/output interface card, designed to interface with proximity probes, velocity sensors and speed pickups. It collects raw vibration and shaft position signals and transmits data to MPC4 protection processor card for calculation and protection judgement. It also has built-in relay outputs for local alarm/trip signals.

Features

• 4 independent measurement channels, support eddy current probe, seismic velocity sensor and speed sensor
• Built-in probe power supply, cable fault detection: short circuit, open circuit, low bias voltage
• On-board 4 Form C relay outputs for local alarm or trip; can extend relays via RLC16 card
• Communicate with MPC4 processor through VM600 backplane OC bus
• Hot-swappable design, pluggable for ABE04X series racks
• Front LED per-channel status indication for sensor, cable and signal health check
• Configurable via VibroSight software, supports shaft vibration, axial position, speed monitoring

Application Scenarios

• Gas turbine, steam turbine shaft vibration and thrust position monitoring
• Centrifugal compressor, large generator, critical pump condition & protection monitoring
• Oil & gas, power plant, refinery rotating machinery protection system
• VM600 rack signal input expansion with MPC4 and RLC16 combination
• Legacy VM600 system spare replacement and retrofit projects

FAQ